5 inch Cobra Fin

This item has changed a little. Screws are not included, holes are NOT pre-drilled, drill your screw holes at 5 inches on center. Use old fin or skeg slot as a guide.

Use as a replacement skeg for all Cobra Kayaks, including the Strike. Also fits: Competition CK, Edge 10 (aka Outlaw by On the Edge Kayaks) and kayaks made by OBI (Ocean Boards International, aka Rage Wave).

This fin is stock on the Cobra ReVision, common on assorted water sport equipment and may be found on some surf kayaks, wave skis and surfboards.

Fin is 5 7/8 in. tall from hull of boat. Screw holes are 5 inches on center. Fin base is 5/8 of an inch wide, 5 3/4 inches long. Skeg fits into a slot molded in the hull with two nut-serts imbedded in the slot. Made of plastic.

Cobra Kayak used 2 stainless steel ¾ inch (10-32) Phillips head or hex cup-head screws to secure these fins.