WS 3-Screw Rudder Pin and Block

WS 3-Screw Rudder Pin and Block
  • Model: KBX-7715-0402 (1D1)
  • Shipping Weight: 0.8lbs
  • 10 Units in Stock

$94.95

Add to Cart:

Best used as a replacement aftermarket retrofit part to address the discontinued the early model Wilderness Systems rudder assembly, circa 1990s. Over all height is 3 7/16 inches, pin is 1 15/16 inches. Pin Length, from bottom of block to rudder pin hole is 1 5/8 inches. The depth of the rudder bracket should not exceed this measurement. A single hole is drilled (for a rudder pin ring) on the end of the 3/8 in. diameter pin. Three 3/16 in. holes, for Hex Bolts and Lock Nuts, and several slots are machined into the black plastic block. Block is approximately 2 3/8 long by 1 1/4 high by 3/4 inches thick, not including removable disc dimension. (Same as part number 7715-0204.)

Important Note: If your kayak is outfitted with the Classic Wilderness Systems Rudder Bracket you will want to get the Classic WS Rudder Pin Tube. See also the Classic Dagger Rudder Rope Tension Kit and the Classic WS Rudder Sheave Set.

Please note that you will have to disassemble your rudder and reassemble it without instructions, but it is fairly simple to do. This part does not fit modern Wilderness Systems kayak models.  RBAP


Copyright © All Rights Reserved 1998 to 2025 TopKayaker®. Powered by Zen Cart
Customized and Hosted by JEANDRET

Valid CSS!