Valley Canoe Products Seat Structure

Oversize Shipping Rates Apply! Please refer to the FAQ page for return information.

Replacement Seat Bottom Structure, aka Seat Pan, for Valley Kayaks. The Standard Plastic molded seat is 19.75 inches wide at the top edge of the seat posts, Mounting Screws are 18.75 inches on center across the cockpit (with a quarter inch of wiggle room each way). Seat is about 7 inches high at the top edge of the seat posts, from a flat surface, about 18.25 inches front to back.

Seat has a close cell foam support block underneath (that can be trimmed to fit) and metal mounting hardware and brackets for each seat post. 

This seat structure is common in sea kayaks made by Valley Canoe Products, such as the Valley Gemini (roto-molded), might be used in other makes and models of sea kayaks. A back band would make the seat complete. SEAASSY