This Kajak Sport Shaft Ferrule is best used as a replacement part. This piece is used by some paddle makers to make a two-part paddle with adjustable feather angle and shaft length. Works instantly for both right and left handed feather. Simple and smooth construction with very easy and reliable operation. KS Shaft ferrule is corrosion free, OK for salt water. A trouble-free and long lasting solution for your paddle.
This clamp is reported as a decent replacement for the OLDER Version Discontinued Adventure Technology AT FeatherLok Paddle Clamp (AT part numbers 9800911 and 5021010). The 211816 clamp is reported to be the best fit to the older AT paddle shafts. To substitute for this Discontinued AT part please select number 211816 from the list menu.
This Kajak Sport paddle clamp might be used as a replacement for the Later Version Discontinued AT Paddle Clamp Body (part number 9800911). The Kajak Sport size to select is unknown at this time. Please read and select carefully!
Please Note: It is assumed that these parts will be glued to your paddle with epoxy. Info on removal of old clamps or center tubes is not available at this time.
This part allows you adjust for multiple size options to any length or feather angle. To be used with the corresponding paddle shaft tube or paddle adjustment tube the best results, as needed.
See the Kajak Sport Paddle Ferule and Shaft Information Page.
Your paddle shaft OD should be same or slightly smaller than the Shaft Opening dimension. Your center connector tube should be close to the Clamp Side dimension.
Size Information by Part Number:
211212 28.5mm Shaft Opening, 26.0mm Clamp Side ID
211412 29.0mm Shaft Opening, 26.0mm Clamp Side ID
211414 29.0mm Shaft Opening, 26.5mm Clamp Side ID
211416 29.0mm Shaft Opening, 27.0mm Clamp Side ID
211612 29.7mm Shaft Opening, 26.0mm Clamp Side ID
211614 29.7mm Shaft Opening, 26.5mm Clamp Side ID
211616 29.7mm Shaft Opening, 27.0mm Clamp Side ID
211618 29.7mm Shaft Opening, 27.5mm Clamp Side ID
211816 30.0mm Shaft Opening, 27.0mm Clamp Side ID
211818 30.0mm Shaft Opening, 27.5mm Clamp Side ID 214056
211820 30.0mm Shaft Opening, 28.0mm Clamp Side ID
Use this link to Convert Millimeters (mm) to Inches (in).
Use the menu to select size option. Stock levels for each size show. New Part Numbers will show in red, expect some minor changes, but is otherwise the same.
