Contact us as needed about the parts below. We have some odd parts in stock from a recently discovered kayak pro shop hoard. We do not have a complete hatch assembly. See more info below.

The Hobie 8 inch Twist-N-Seal Hatch was a Hinged Cover with Twist Lock closure. Hatch rim is 11 1/8 inches OD. Screw holes are 10 1/4 inches on center, across. Came with a foam rubber deck gasket and instructions. Mounting hardware was not included. (Applicable part numbers 71702001 and 71702011.) NESC

Hobie 8 Inch Twist-N-Seal Hatch had same foot print as Viking 8 Twist Lock Hatch. Both can be substituted with the Sea-Lect 10 inch Rubber Cover and Ring.

Hobie Twist-N-Seal Hatch Handle was best used as a replacement handle for the Hobie Eight Inch Twist-N-Seal Hatch, presumed to also fit the Hobie Six Inch too. Handle is marked LOCKED on one side and UNLOCKED on the other. Approximately 2 3/8 by 2 inches with a steel roll pin. (Hobie part number 71702.)

Hobie 8 Inch O-Ring for Twist-N-Seal Hatch was best used as a replacement O-Ring for the 8 inch hatch. It is recommend to lubricate this O-Ring with silicone grease. (Hobie part number 71702021.)

We have one used handle, 2 new O-Rings both as partial assemblies. Or... We have enough separate parts for you to build one Hobie 8 inch Twist-N-Seal Hatch. Contact us as needed about these parts.