Oversize Shipping Rates Apply! Please refer to the FAQ page for return information.
Replacement seat for the Perception Acadia II tandem kayak. This seat may fit other recreational kayaks, such as the Perception Swift Water Tandem. Please measure carefully and compare before placing your order. The Acadia II Seat (alt part number 18500644) has an over all height of 16 inches at the top of the seat back. It is 26 inches at its widest and measures 21.5 inches in total length. The Acadia II seat has a hinged back support, that folds down. Both the seat back and seat bottom are outfitted with thermo-form foam padding. The seat bottom is grooved to match the ridges on the Acadia II floor. The seat bottom has arms at the sides, like an armchair. These arms are drilled out with 1.25 inch diameter holes to fit the side tubes under the gunwales of the cockpit. Holes are 23.25 inches on center, 22 inches apart. The front seat in an Acadia II is meant to slide on these bars, forward and aft, to trim the kayak’s load when solo paddling. Your bars should be about 22 inches apart. The rear seat is bolted to the gunwale, into the arms. Additional holes in the arms provide access for through bolting. Seat is hollow, molded, black plastic. It is assumed that this seat will fit a two-man kayak about 33 inches wide, give or take. Call 603-651-1036 for more information. SEAASSY PERRECTOUR